Rohde&Schwarz UPV B3/K4 Audio Analyzer SOLD OUT sold
log502
Front side
came off button
Analog Sine 1V 1kHz THD
Analog Sine 1V 1kHz THD
Analog Square 1V 1kHz THD
Firmware ver 4.0.4.159
Installed Option B3/K4
Rear side
Accessory
Came off button(Please check red circle)
Dual-Channel Input Level measurement(RMS):+-0.05dB,typ+-0.025dB(at1kHz) XLR Connectors:2channel balanced, Voltage Range:o.1uV to 110V(RMS,sine) Measurment ranges:18mV to 100V in step of 5dB Input Impedance:100kohm+-1%shunted by 120pF
Analog Generators: Balanced Voltage:0.1mV to 20V,(RMS,Sine,open circuit) Crosstalk attenuation:>115dB(frequency <20kHz) Source Impedance:typ 10ohm,200ohm,,600ohm, Load Impedance:>400ohm(incl source;impedance)
Unbalanced Voltage:0.1mV to 10V(RMS,sine,opencircuit), Crosstalk attenuation:>115dB(Frequency<20kHz), Source impedance:typ 5ohm, Load impedance:>200ohm, Signals: Frequency range:0.1Hz to 80kHz, Frequency Error:+-10ppm, Level Error:+-0.05dB, Frequency Response:+-0.01/+-0.05/+-0.1dB (20Hz to 20/70/80kHz), Inherent Distortion(THD+N):Level<3V,<-103dB+2.5uV, Wave type:Sine,MOD DiST,DFD,DIM,Sine Burst, NOISE,Arbitary waveform,Polarity test Signal,FM Signal, AM Signal,DC Voltage,DC Offset, FFT Analysis: Frequency Range:DC to 22.5kHz/43.5kHz,87kHz,250kHz, Dynamic Range:120dB(analog bandwidth 22k/40k/80kHz), 100dB(analog bandwidth 250kHz), Noise floor:-140dB(analog bandwidth 22k/40k/80kHz), -120dB(analog bandwidth 250kHz), FFT Size:512/1k/2k/4k/8k/16k/32k/64k/128k/256k points, Window function:rectangular,Hann,Blackman-Harris,Rife-Vincent1-3,Hamming,flat top, Filter; Weighting filters:A weighting,C weighting,CCIR 1k weighted,CCIR 2k weighted,CCIR un weighted,CCITT,C message,DC noise highpass,deemphasis 50/15,50,75, deemphasis J.17,50/15,50,75,IEC tuner,jitter weighted, runble weighted, Highpass and lowpass filters:highpass 22Hz,Highpass 400Hz,lowpass 22kHz,lowpass 30kHz,lowpass 80kHz, Sweep Parameters:Frequency,Level,with bursts also interval and duration,one-or two-dimensional, Sweep:Linear,Logarithmic,single,continuous, Stepping:Automatic after end of measurement,
Power supply:AC 100/120/220/240V @50 or 60Hz, Dimentions:465(W)-197(H)-495(D)mm, Weight:15.0kg,
Maker price:JPY2,324,000-
Opt K4:Remote Control:Enables remote control via IEC625-2(IEEE 488)GP-IB,LAN and USB B3:Second analog generator;0.1Hz- 80kHz
)
)
)
)
)
)
)
)
)